RISE
  • Home
  • the Hub!
    • Arduino Robotics Basic
    • Laser Fundamentals
  • About
  • Contact
  • Support RISE
  • New Page

Laser Fundamentals using Inkskape

Picture
In this course students will learn the following:
       2D Design in Inscape.
       Mechanical Measurements and Drafting
       2D Design for  fabrication. 
       Fundamentals of Laser Cutter/Engraver Utilization.
       Hands-On Laser Engraver Operation.

Cost: $145
Length: 8-9hours
Laptop able to load and run Inkscape Required
Registration Information:

June 28/29 Class - 13-18 years old - Class#062922 (12 slots available)
9:00am to 2:30pm (please bring a sack lunch)
Location: 9420 Activity Road Suite H

Registration closes on June 25th. More information will be sent to the contact emails submitted in the registration including a waiver and payment link which must also be completed by June 25th.

Please note: Classes will be cancelled if there are less than 4 students registered

Click Here to Register

Questions?: Email Victor@rise4steam.org​​
Proudly powered by Weebly
  • Home
  • the Hub!
    • Arduino Robotics Basic
    • Laser Fundamentals
  • About
  • Contact
  • Support RISE
  • New Page